淡江大學機構典藏:Item 987654321/94586
English  |  正體中文  |  简体中文  |  全文笔数/总笔数 : 62822/95882 (66%)
造访人次 : 4018022      在线人数 : 826
RC Version 7.0 © Powered By DSPACE, MIT. Enhanced by NTU Library & TKU Library IR team.
搜寻范围 查询小技巧：
  • 您可在西文检索词汇前后加上"双引号"，以获取较精准的检索结果
  • 若欲以作者姓名搜寻，建议至进阶搜寻限定作者字段，可获得较完整数据
    •  进阶搜寻


    jsp.display-item.identifier=請使用永久網址來引用或連結此文件: https://tkuir.lib.tku.edu.tw/dspace/handle/987654321/94586


    题名: 粒狀氫氧化鐵去除水中鉬之研究
    其它题名: Removal of molybdenum from water by granular ferric hydroxide
    作者: 連思琦;Lien, Szu-Chi
    贡献者: 淡江大學水資源及環境工程學系碩士班
    康世芳
    关键词: 鉬;吸附;粒狀氫氧化鐵;等溫吸附;動力吸附;molybdenum;adsorption;granular ferric hydroxide;Freundlich isotherm;adsorption kinetic;competitive anions
    日期: 2013
    上传时间: 2014-01-23 14:47:45 (UTC+8)
    摘要: 台灣環保署於2008年增訂飲用水水質標準管制鉬0.07 mg/L，本研究評估粒狀氫氧化鐵(GFH)吸附去除水中鉬(Mo)。以ICP-MS分析級(NH4)2MoO4藥劑配製含Mo水樣，操作參數為GFH添加量、pH、Mo初始濃度、接觸時間、溫度及競爭離子(氯鹽、硝酸鹽、硫酸鹽、磷酸鹽)，研究目的為探討:(1)探討操作參數對GFH吸附Mo之影響、(2)GFH吸附Mo之等溫吸附、及(3) GFH吸附Mo之動力吸附。實驗採批次式等溫吸附與動力吸附實驗。
    研究結果顯示GFH吸附劑去除Mo可達80%以上，但粉末活性碳與粉末活性鋁去除Mo低於25%，故本研究選擇GFH為吸附劑。GFH表面等電點pH為7.0，吸附Mo之最適pH範圍為4-7，其鉬吸附量為pH 9-10之約5倍。相同GFH添加量，Mo初始濃度越高則對Mo吸附量越大，最大吸附量為25 mg/g；相同Mo初始濃度下，GFH添加量越高，每單位GFH對Mo之吸附量越低。溫度對GFH吸附Mo之效果依序為45℃>25℃>10℃。競爭離子以磷酸鹽對GFH吸附Mo影響效果最為顯著，氯鹽、硝酸鹽、硫酸鹽則無顯著影響。此外，GFH吸附Mo可遵循Freundlich等溫吸附式。吸附強度n值大於1，屬於自發性反應；n值隨Mo初始濃度及溫度增加而增加。動力吸附可遵循Lagergern二階(Pseudo-second-order)動力吸附模式。二階動力常數k2值隨GFH添加量增加呈線性增加，但隨Mo初始濃度增加而減小。
    The Taiwan Environmental Protection Agency enforced molybdenum regulation of 0.07 mg/L in drinking water quality standards in 2008. This study evaluates the adsorption of molybdenum (Mo) by granular ferric hydroxide (GFH). All experiments are conducted by batch isothermal and kinetic adsorption methods. The experimental parameters include type and dosage of GFH, pH, initial Mo concentration, contact time, temperature and competitive anions. Moreover, the Mo-containing water sample is prepared from (NH4)2MoO4 ICP-MS analytical-grade solution. The purpose of this study are to investigate (1) the effect of experimental parameters on the adsorption of Mo by GFH, (2) the isothermal adsorption of Mo by GFH, and (3) kinetic adsorption of Mo by GFH.
    The results show that the removal of Mo could reach more than 80% by GFH, in contrast, it was less than 25% by both powdered activated carbon and powdered activated aluminum. Thus, GFH was selected as an adsorbent for adsorption of Mo in this study. The isoelectric point of GFH surface was 7.0. The optimum pH for GFH adsorption of Mo ranged from 4 to 7 and the amount of adsorbed Mo is about 5 times as that at pH 9-10. For the same GFH dosage, the amount of adsorbed Mo increased with increasing initial concentration of Mo and the maximum adsorption capacity reached to 25 mg-Mo/g-GFH. However, it decreased with increasing GFH dosage for the same initial concentration of Mo. The order of adsorption efficiency by temperature was 45oC>25oC >10oC. The effect of PO43- on the adsorption of Mo was observed to be stronger than that of Cl-, NO3-, SO42-. Furthermore, the adsorption data fitted the Freundlich isotherm model well. The n value in Freundlich isotherm model was increased with increasing both initial concentration of Mo and temperature. The kinetic adsorption followed the Lagergern pseudo-second-order kinetics. The adsorption rate constant, k2 value increased linearly with increasing GFH dosage, while it decreased with increasing initial concentration of Mo.
    显示于类别:[水資源及環境工程學系暨研究所] 學位論文

    文件中的档案:

    档案 大小格式浏览次数
    index.html0KbHTML170检视/开启

    在機構典藏中所有的数据项都受到原著作权保护.

    TAIR相关文章

    DSpace Software Copyright © 2002-2004  MIT &  Hewlett-Packard  /   Enhanced by   NTU Library & TKU Library IR teams. Copyright ©   - 回馈