Fabrication of polydimethylsiloxane (PDMS) pulsating heat pipe

doi:10.1016/j.applthermaleng.2008.03.028

淡江大學機構典藏 > 工學院 > 機械與機電工程學系暨研究所 > 期刊論文 > Item 987654321/50537

請使用永久網址來引用或連結此文件: https://tkuir.lib.tku.edu.tw/dspace/handle/987654321/50537

題名:	Fabrication of polydimethylsiloxane (PDMS) pulsating heat pipe
作者:	Lin, Yu-hsing;康尚文;Kang, Shung-wen;Wu, Tsung-yu
貢獻者:	淡江大學機械與機電工程學系
關鍵詞:	PDMS;Pulsating heat pipes;Turn over the mould;Filled ratio
日期:	2009-02-01
上傳時間:	2010-08-09 19:25:54 (UTC+8)
出版者:	Elsevier
摘要:	This paper reports on the preliminary experimental results of using polydimethylsiloxane (PDMS) to manufacture a visual pulsating heat pipe with length, width and internal diameter of 56 mm, 50 mm and 2 mm, respectively, including the manufacturing process, the vacuuming management for filling and packaging. The experiment used methanol and ethanol as working fluids. A fix filled ratio (about 60%) and different heating power values (3–8 W) were used to test the thermal performance. A high-speed video camera was used to record the working situation of the working fluid inside the channel. The results are discussed and analyzed. The experiment shows that methanol, in a vertical orientation, shows the most efficient results. When the heating power is 3 W, the thermal resistance is more than 4.5 °C/W below the value for ethanol as the working fluid. For a heating power of 4 W, the average temperature decreases to 15 °C in the evaporator. Also, gravity will have an impact on the PHP performance: the vertical orientation is better as compared to the horizontal orientation.
關聯:	Applied Thermal Engineering 29(2-3), pp.573-580
DOI:	10.1016/j.applthermaleng.2008.03.028
顯示於類別:	[機械與機電工程學系暨研究所] 期刊論文

文件中的檔案:

檔案	描述	大小	格式	瀏覽次數
1359-4311_29(2-3)p573-580.pdf		634Kb	Adobe PDF	364	檢視/開啟
Fabrication of polydimethylsiloxane (PDMS) pulsating heat pipe.pdf		634Kb	Adobe PDF	2	檢視/開啟

在機構典藏中所有的資料項目都受到原著作權保護.

TAIR相關文章

資料載入中.....