淡江大學機構典藏:Item 987654321/45816
English  |  正體中文  |  简体中文  |  全文筆數/總筆數 : 62830/95882 (66%)
造訪人次 : 4155766      線上人數 : 712
RC Version 7.0 © Powered By DSPACE, MIT. Enhanced by NTU Library & TKU Library IR team.
搜尋範圍 查詢小技巧：
  • 您可在西文檢索詞彙前後加上"雙引號"，以獲取較精準的檢索結果
  • 若欲以作者姓名搜尋，建議至進階搜尋限定作者欄位，可獲得較完整資料
    •  進階搜尋


    請使用永久網址來引用或連結此文件: https://tkuir.lib.tku.edu.tw/dspace/handle/987654321/45816


    題名: Ductile behaviour in single-point diamond-turning of single-crystal silicon
    作者: Chao, C. L.;Ma, K. J.;Liu, D. S.;Bai, C. Y.;Shy, T. L.
    貢獻者: 淡江大學機械與機電工程學系
    關鍵詞: Silicon;Single-crystal;Diamond
    日期: 2002-09-01
    上傳時間: 2010-03-26 20:01:12 (UTC+8)
    出版者: Elsevier
    摘要: Single-crystal silicon is usually considered to be extremely brittle and exhibit little ductility in machining. In work reported in the literature during indentation tests, cracks appeared around the impression at loads as small as 5 g and the crystallographic direction was found to have a strong influence on the crack initiation and propagation; however, spiral and flake-like swarf were observed in the single-point diamond-turning of single-crystal silicon. This means that, under some carefully chosen machining conditions, it is possible for single-crystal silicon to be deformed in a ductile manner. The implication of this “ductile behaviour” is to enable single-crystal silicon to be diamond-turned/ground in ductile-mode. In the present research, diamond tools with different tool geometries were employed to diamond-turned single-crystal silicon. Cutting speeds ranged from near 0 to 150 m/min. The results showed that, given the same machining conditions, where rapid tool wear and poor surface finish were obtained when round-nosed tools were used, surfaces with Ra better than 5 nm and no obvious tool wear were achieved by using a ruling tool. This means that the tool geometry has profound effects on the material removal mechanisms involved and on the tool wear rate and that it is possible to reduce tool wear and improve surface finish by carefully modifying the tool shape.
    關聯: Journal of materials processing technology 127(2), pp.187-190
    DOI: 10.1016/S0924-0136(02)00124-3
    顯示於類別:[機械與機電工程學系暨研究所] 期刊論文

    文件中的檔案:

    檔案 描述 大小格式瀏覽次數
    1-s2.0-S0924013602001243-main.pdf278KbAdobe PDF0檢視/開啟
    index.html0KbHTML199檢視/開啟

    在機構典藏中所有的資料項目都受到原著作權保護.

    TAIR相關文章

    DSpace Software Copyright © 2002-2004  MIT &  Hewlett-Packard  /   Enhanced by   NTU Library & TKU Library IR teams. Copyright ©   - 回饋