Fabrication and test of radial grooved micro heat pipes

淡江大學機構典藏 > 工學院 > 機械與機電工程學系暨研究所 > 期刊論文 > Item 987654321/45665

請使用永久網址來引用或連結此文件: https://tkuir.lib.tku.edu.tw/dspace/handle/987654321/45665

題名:	Fabrication and test of radial grooved micro heat pipes
作者:	康尚文;Kang , Shung-wen;Tsai, Sheng-hong;Chen, Hong-chih
貢獻者:	淡江大學機械與機電工程學系
關鍵詞:	Micro heat pipe;Bulk micromachining;Eutectic bonding
日期:	2002-10-01
上傳時間:	2010-03-26 19:43:06 (UTC+8)
出版者:	Elsevier
摘要:	This paper describes the development of radial grooved micro heat pipes (MHPs) with a three-layer structure. The MHPs were designed to allow separation of the liquid and vapor flow to reduce the viscous shear force. The 5×5 cm2 MHP array was fabricated by using bulk micromachining and eutectic bonding techniques on 4-in. (1 0 0) silicon wafers. Experiments were undertaken to evaluate the performance of wafers with three different wafer fill rates at different input powers. We glued a heater below the evaporator section, pumped cold water through a square copper heat exchanger above the heat pipe, and pasted 15 K-type thermocouples on both sides of MHP structure to record the variations of surface temperature. After the evaluation, the MHP with 70% fill rate showed the best performance as compared to samples with smaller fill rates.
關聯:	Applied thermal engineering 22(14), pp.1559-1568
DOI:	10.1016/S1359-4311(02)00085-6
顯示於類別:	[機械與機電工程學系暨研究所] 期刊論文

文件中的檔案:

檔案	描述	大小	格式	瀏覽次數
		0Kb	Unknown	537	檢視/開啟
Fabrication and test of radial grooved micro heat pipes.pdf		415Kb	Adobe PDF	1	檢視/開啟

在機構典藏中所有的資料項目都受到原著作權保護.

TAIR相關文章