淡江大學機構典藏:Item 987654321/106565
English  |  正體中文  |  简体中文  |  全文筆數/總筆數 : 62805/95882 (66%)
造訪人次 : 3922966      線上人數 : 500
RC Version 7.0 © Powered By DSPACE, MIT. Enhanced by NTU Library & TKU Library IR team.
搜尋範圍 查詢小技巧：
  • 您可在西文檢索詞彙前後加上"雙引號"，以獲取較精準的檢索結果
  • 若欲以作者姓名搜尋，建議至進階搜尋限定作者欄位，可獲得較完整資料
    •  進階搜尋


    請使用永久網址來引用或連結此文件: https://tkuir.lib.tku.edu.tw/dspace/handle/987654321/106565


    題名: Influences of shear rate on the mechanical behaviors of artificial rock joints with regular asperities
    關鍵詞: Regular Asperity;Shear Rate;Rock Joint;Double-Shear Test;Failure Area Ratio
    日期: 2014-10-14
    上傳時間: 2016-04-27 11:17:10 (UTC+8)
    出版者: International Society for Rock Mechanics
    摘要: In this study, the effects of shear rate on the mechanical behaviors of artificial rock joints with regular asperities have been studied by a series of double-shear tests. The adopted simulated material composed of gypsum, quartz sand and water was used to simulate rock joints with regular asperities 00, 150 and 300. A number of double-shear tests were performed by using a material testing machine (MTS 819 High Rate Test System) and the rate of shear displacement was controlled in the range of 10-2–101 mm/sec. A set of the artificial rock joints contained two sliding surface and was tested under constant normal load (CNL) boundary condition, and the range of normal stress was 0.1–0.7 (MPa) applied by a pair of pneumatic cylinders. Experimental results show that the shear displacement curves exist obvious stick-slip phenomenon especially in low shear rate and high normal stress for smooth rock joints. The shear stiffness of the smooth joints normalized by normal stress has a semilogarithmic linear relationship with normalized shear rate. The dilation angle is decreasing with the increasing of normal stress level, and the decreased tendency is evident especially at asperities 300; however, the trends of dilation angle varied with shear rate are different with asperities 150 and 300 as a result of varieties of failure modes. The increasing tendency of the slope of shear strength envelopes is related to the raising of shear rate. In order to distinguish the influences of normal stress level and shear rate on the failure of regular asperities, the failure area ratio (FAR) is defined as the area ratio of shearing failure part and pre-shearing surface. It is found that the FAR has a tendency to increase with the raising of normal stress level but exist no obvious relation with shear rate.
    關聯: 8thAsian Rock Mechanics Symposium
    顯示於類別:[土木工程學系暨研究所] 會議論文

    文件中的檔案:

    檔案 描述 大小格式瀏覽次數
    index.html全文0KbHTML136檢視/開啟
    index.html議程0KbHTML122檢視/開啟

    在機構典藏中所有的資料項目都受到原著作權保護.

    TAIR相關文章

    DSpace Software Copyright © 2002-2004  MIT &  Hewlett-Packard  /   Enhanced by   NTU Library & TKU Library IR teams. Copyright ©   - 回饋